HIKVISION DS-K1T605 Series User Manual

Before You Start
Before seng the capture parameters, you should set the picture
storage rst to dene where the captured pictures are saved. For
details, refer to .
Steps
Note
This funcon should be supported by the device
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters Capture .
3.
Select an access control device in the device list and select
Linked Capture.
4.
Set the picture size and quality.
5.
Set the capture
mes once triggered which denes how many
pictures will be captures for one me.
6.
If the capture mes is more than 1, set the interval for each
capture.
7.
Click Save.
Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually
the access control device's camera by clicking a buon. Before
that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before
seng the capture parameters, you should set the saving
path rst to dene where the captured pictures are saved. For
details, refer to .
Steps
Note
This funcon should be supported by the device
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters Capture .
3.
Select an access control device in the device list and select
Manual Capture.
4.
Select the
resoluon of the captured pictures from the drop-
down list.
5.
Select the picture quality as High, Medium, or Low. The higher
the picture quality is, the larger size the picture will be.
6.
Click Save.
Set Parameters for Face Recognion Terminal
For face recognion terminal, you can set its parameters
including face picture database, QR code
authencaon, etc.
Steps
Note
This funcon should be supported by the device.
1.
Enter the Access Control module.
67

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English