HIKVISION DS-K1T605 Series - Page 75

7.
Enter the port number for the protocol.
Note
The port number of the wireless network and wired network
should be consistent with the port number of EHome.
8.
Select the Protocol Type as EHome.
9.
Set an account name for the network center.
10.
Click Save.
Create EHome Account in Wireless Communicaon Mode
You can set the account for EHome protocol in wireless
communicaon mode. Then you can add devices via EHome
protocol.
Steps
Note
This funcon should be supported by the device
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon
More Parameters .
3.
Select an access control device in the device list and enter
Network Wireless Communicaon Center .
4.
Select the APN Name as CMNET or UNINET.
5.
Enter the SIM Card No.
6.
Select the center group from the drop-down list.
7.
Enter the IP address and port number.
Note
•
By default, the port number for EHome is 7660.
•
The port number of the wireless network and wired network
should be consistent with the port number of EHome.
8.
Select the Protocol Type as EHome.
9.
Set an account name for the network center.
10.
Click Save.
Set Device Capture Parameters
You can congure the capture parameters of the access control
device, including manual capture and event triggered capture.
Note
•
The capture funcon should be supported by the device.
•
Before seng the capture parameters, you should set the
picture storage rst to dene where the event triggered
pictures are saved. For details, refer to .
Set Triggered Capture Parameters
When an event occurs, the camera of the access control device
can be triggered to capture picture(s) to record what happens
when the event occurs. You can view the captured pictures when
checking the event details in Event Center. Before that, you need
to set the parameters for the capture such as number of pictures
captured for one
me.
66