Hioki ST5540 - Page 313

Appendix3 List of default settings
A23
Appendix
Free current measurement manual manual manual
polarity positive phase positive phase –
equipment
status
normal normal normal
Other applied
voltages
OFF OFF OFF
Application of
specific voltage
–––
s10 OFF OFF –
s12 OFF OFF –
s13–––
filter ON ON ON
target current ACDC ACDC ACDC
range AUTO AUTO AUTO
allowable value
: upper limit :
normal
100.0
A100.0 A 100.0 A
allowable value
: upper limit :
fault
500.0
A500.0 A–
allowable value
: lower limit :
ON/OFF :
normal
OFF OFF OFF
allowable value
: lower limit :
ON/OFF : fault
OFF OFF –
default setting
Class I Class II Internally powered
Leakage
current mode
item Type B Type BF Type CF Type B Type BF Type CF Type B Type BF Type CF
*
( ) is the value after DC switching