Hitachi IJ UX Service Manual

6-27
6.2.28 Makeup Level Sensor Broken (3)
[CAUTION]
1. If Makeup Level Sensor Broken (3) is issued, the machine stops ejecting ink and becomes Fault
status.
Makeup Level Sensor
Broken (3).
Restart IJP and go to “Level
sensor confirmation” screen
and check if all sensors
contained in Makeup reservoir
work properly.
End
Replace EZJ126 board.
Turn OFF
power.
Any disconnection or
poor connection is found
at CN13 connector on
EZJ126 board or CN1 or
CN3 connector on
EZJ132 board?
Remove the connector once and
reconnect it
Does the connection
harness have
electrical continuity?
Replace the connection harness
No
Yes
No
Yes
Replace the sensor block
of Makeup reservoir.
Yes
No
Yes
No
Go to “Level sensor confirmation”
screen and check if all sensors
contained in Makeup reservoir work
properly.

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English