Hitachi IJ UX Service Manual

2-53
● Automatic ink & makeup replenishment sequence
Printing
(30 minutes)
Viscosity
measurement
Waiting for
defoaming
(10 minutes)
Ink
replenishment
(for dot count)
Makeup
replenishment
Ink
replenishment
(to initial level)
<Log timing>
(1) Except Pigment model: End of Step B1
(2) Pigment model: End of Step B2
● Mode (Result of Automatic ink replenishment)
- Normal end
Mode = 1: Normal end at Step B1 or Step B2.
- The main tank ink level is higher than initial level when increasing or reducing
concentration control.
= 2: Normal end at Step C1.
- The main tank ink level becomes higher than initial level after ink
replenishment for dot count.
= 4: Normal end at Step C2
= 5: Normal end at Step C3
- Abnormal end or terminated
Mode = A: Abnormal end at step B1
= B: Terminated at step B1
= C: Abnormal end at step B2
= D: Terminated at step B2
= E: Abnormal end at step C1
= F: Terminated at step C1
= G: Abnormal end at step C2
= H: Terminated at step C2
= J: Abnormal end at step C3
= K: Terminated at step C3
(1) (2)
Step B1
Step B2 Step C1
Step C2
Step C3
Step B2 is for Pigment ink only.

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English