Hitachi UX Twin Nozzle - Page 302

6-60
6.3.19a (N1)Free layout printing failure
6.3.19b (N2)Free layout printing failure
When the print format is set to Free layout, the printing may NOT be completed depending on the
data amount being created, of the print items or characters. In this case, warning of “Free layout
printing failure” will be displayed. For the details of the Free layout, refer to “ 4.8 Set print format
(Free layout) “ in Instruction Manual.
[ SUPPLIMENT ]
Resume the
operation.
(N1)Free layout printing failure
Delete the specific print items or Decrease the Ink drop use
rate. ( ex. 1/2→1/3)
Does the fault recur?
No
Yes
Resume the
operation.
(N2)Free layout printing failure
Delete the specific print items or Decrease the Ink drop use
rate. ( ex. 1/2→1/3)
Does the fault recur?
No
Yes