Hitachi UX Twin Nozzle - Page 82

3-6
(11) Confirm “Serial number” on the “Unit information” screen and then confirm the
date and time.
(12) Recover the data from the back up memory by using "Copy data (USB→IJP)"
function.
(Data is from USB memory to IJ printer)
(Note. 1) "Print data" means the data of print description, print specification, the print line,
print format, calendar and count.
(Note. 2) Unit-data means ink type, nozzle diameter and viscosity calibration data.
- When the EZJ128 board is replaced with having NO backup available, follow the
procedures below.
[Replacement procedures of EZJ128 board with NO back up is available]
(1) Turn off the power.
(2) Open the control panel and remove connection cable and battery on the EZJ128
board.
(3) Replace the EZJ128 board.
(4) Attach the connection cable and battery to the EZJ128 board.
(5) Turn on the power with system data USB memory inserted.
(6) Execute “System reset” on the second page of the service maintenance screen.
(7) Confirm “Serial number” on the “Unit information” screen and then confirm the
date and time.
(8) Set or adjust the data according to the following table.
No.
Item
Reference manual
1
Calibrate touch screen
coordinates
Instruction manual
“7.4 Calibrating the Touch Screen coordinates”
2
Touch screen setup
Instruction manual “6.3 Touch screen setup”
3
Selection of ink type
“2.2 System environment setup”
4
Nozzle diameter setting
“2.2 System environment setup”
5
Excitation adjustment
“2.3.1 Excitation adjustment”
6
Viscometer calibration or
Viscosity coefficient input
“2.6.1 Calibration of viscometer” or input ink viscosity
coefficient on “2.10 Unit information”
7
Adjustment of auto phase
gain value
“2.3.4 Auto phase gain adjustment”
8
Excitation voltage setting
Technical manual “6.10 Excitation V Adjustment”
9
Readjustment of auto phase
gain value
“2.3.4 Auto phase gain adjustment”
10
Editing print data
Instruction manual “4.Creation and printing of message”
11
Setting of substitution rules
Instruction manual
“4.10.3 Print by substituting a different character for the
date (Substitution rule)”
12
Creating a User pattern
Instruction manual “7.3 Creating a user pattern”
13
User environment setup
Instruction manual “6.1 Setting the user environment”
14
Setting the Date and Time
Instruction manual “6.2 Setting a Date and Time”
15
Setting Communication
environment
Technical manual “5 Communication”
16
Setting the Password
Technical manual “3.2 Setting functions which can be
performed”
For backup data function, the data type to be saved is different between the service
personnel maintenance mode and user maintenance mode. When replacing the EZJ128
board, change the mode to the service personnel maintenance mode and then perform
the backup.
-User mode: User data (print data (Note 1), substitution rules, user patterns)
-Service personnel maintenance mode:
User data (same as above) and unit-specific data (Note 2).
After replacing the EZJ128 board, turn ON the power of the IJ printer and confirm the
date and time. If the date and time displayed is not correct, adjust the setting again.
Caution
!
As for the Unit
Information, see “2.10
Unit information”.
As for the System
reset, see “2.8 System
reset”.