FUEL SYSTEM (PGM-FI)
5-38
2. MAP Sensor Output Voltage Inspection
Connect the ECM test harness to ECM connec-
tors (page 5-14).
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the test harness termi-
nals.
The MAP sensor voltage should be changed
after engine started.
Is the voltage within 2.7 – 3.1 V?
YES – GO TO STEP 3.
NO – Faulty MAP sensor
3. MAP Sensor Output Voltage Inspection At Idle
Start the engine.
Measure the voltage at the test harness termi-
nals.
Is the voltage less than 2.7 V?
YES – Replace the ECM with a known good
one, and recheck; refer to Key Registra-
tion Procedures (page 21-6)
NO – Faulty MAP sensor
MIL7BLINKS(ECTSENSOR)
• Before starting the inspection, check for loose or
poor contact on the ECT sensor 3P (Black) con-
nector and ECM 33P connectors, then recheck
the MIL blinking.
1. ECT Sensor Output Voltage Inspection
Turn the ignition switch OFF.
Connect the test harness to ECM 33P connectors
(page 5-14).
Turn the ignition switch ON and engine stop
switch " ".
Measure the voltage at the test harness termi-
nals.
Is the voltage within 2.7 – 3.1 V?
YES – Intermittent failure
NO – GO TO STEP 2.
CONNECTION: B9 (+) – A18 (–)
TEST HARNESS PIN BOX
(A TERMINALS)
TEST HARNESS PIN BOX
(B TERMINALS)
(A18)
(B9)
CONNECTION: B9 (+) – A18 (–)
STANDARD: 2.7 V maximum
TEST HARNESS PIN BOX
(A TERMINALS)
TEST HARNESS PIN BOX
(B TERMINALS)
(A18)
(B9)
CONNECTION: B13 (+) – A18 (–)
STANDARD: 2.7 – 3.1 V (20°C/68°F)
TEST HARNESS PIN BOX
(A TERMINALS)
TEST HARNESS PIN BOX
(B TERMINALS)
(A18) (B13)
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
