HYDRAULIC BRAKE
15-23
Install the brake light switch and tighten the screw.
Apply silicone grease to the brake lever pivot bolt
sliding surface.
Install the brake lever and pivot bolt, and tighten it.
Install the nut and tighten it while holding the pivot
bolt.
INSTALLATION
Place the master cylinder assembly on the handle-
bar.
Align the end of the master cylinder with the punch
mark on the handlebar.
Install the master cylinder holder with the "UP"
mark facing up.
Tighten the upper bolt first, then the lower bolt to
the specified torque.
Connect the brake hose to the master cylinder with
the oil bolt and new sealing washers.
Tighten the oil bolt while holding the hose eyelet
against the stopper.
Install the rear view mirror (page 13-11).
TORQUE: 1.2 N·m(0.1kgf·m, 0.9 lbf·ft)
TORQUE: 1.0 N·m(0.1kgf·m, 0.7 lbf·ft)
TORQUE: 5.9 N·m(0.6kgf·m, 4.4 lbf·ft)
TORQUE: 12 N·m(1.2kgf·m, 9 lbf·ft)
MASTER CYLINDER
BOLTS
HOLDER
"UP" MARK
PUNCH MARK
TORQUE: 34 N·m(3.5kgf·m, 25 lbf·ft)
CBF600N/NA only:
CONNECTORS
OIL BOLT
SEALING WASHERS
BRAKE HOSE
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk
To Next Page
