Honeywell HH490 - USB

182 HH490 User Guide
Selection
Setting
* Indicates default
Serial Command #
Indicates a numeric entry
Page
Validate Type 11 then Type 10 Char, but
Don’t Transmit
MSICHK4 118
Validate Type 11 then Type 10 Char and
Transmit
MSICHK5 119
Disable MSI Check Characters MSICHK6 119
MSI Message Length Minimum (4 - 48) *4 MSIMIN## 119
Maximum (4 - 48) *48 MSIMAX## 119
GS1 DataBar Omnidirectional Default All GS1 DataBar Omnidirectional
Settings
RSSDFT 119
Off RSSENA0 119
*On RSSENA1 119
GS1 DataBar Limited Default All GS1 DataBar Limited Settings RSLDFT 120
Off RSLENA0 120
*On RSLENA1 120
GS1 DataBar Expanded Default All GS1 DataBar Expanded
Settings
RSEDFT 120
Off RSEENA0 120
*On RSEENA1 120
GS1 DataBar Expanded Msg.
Length
Minimum (4 - 74) *4 RSEMIN## 121
Maximum (4 - 74) *74 RSEMAX## 121
Trioptic Code *Off TRIENA0 121
On TRIENA1 121
Codablock A Default All Codablock A Settings CBADFT 121
*Off CBAENA0 121
On CBAENA1 121
Codablock A Msg. Length Minimum (1 - 600) *1 CBAMIN### 122
Maximum (1 - 600) *600 CBAMAX### 122
Codablock F Default All Codablock F Settings CBFDFT 122
*Off CBFENA0 122
On CBFENA1 122
Codablock F Msg. Length Minimum (1 - 2048) *1 CBFMIN#### 123
Maximum (1 - 2048) *2048 CBFMAX#### 123
Label Code On LBLENA1 123
*Off LBLENA0 123
PDF417 Default All PDF417 Settings PDFDFT 123
*On PDFENA1 123
Off PDFENA0 123
PDF417 Msg. Length Minimum (1-2750) *1 PDFMIN#### 124
Maximum (1-2750) *2750 PDFMAX#### 124