Honeywell HH490 - Inspect Cords and Connectors

184 HH490 User Guide
Selection
Setting
* Indicates default
Serial Command #
Indicates a numeric entry
Page
On DIGENA1 131
Uses ID Decoder then Both Decoders DIGENA2 132
Uses Digimarc Decoder then Both
Decoders
DIGENA3 132
Uses ID Decoder then Alternates
Decoders
DIGENA4 132
Uses Digimarc Decoder then Alternates
Decoders
DIGENA5 132
Data Matrix Default All Data Matrix Settings IDMDFT 132
*On IDMENA1 132
Off IDMENA0 132
Direct Part Marking (DPM)
Decoding
Dotpeen DPM Decoding DPMENA1 133
*Disable DPM Decoding DPMENA0 133
Reflective (Etched) DPM Decoding DPMENA2 133
Data Matrix Msg. Length Minimum (1-3116) *1 IDMMIN#### 133
Maximum (1-3116) *3116 IDMMAX#### 133
Data Matrix Code Page Data Matrix Code Page (*51) IDMDCP## 133
MaxiCode Default All MaxiCode Settings MAXDFT 134
On MAXENA1 134
*Off MAXENA0 134
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN### 134
Maximum (1-150) *150 MAXMAX### 134
Aztec Code Default All Aztec Code Settings AZTDFT 134
On AZTENA1 135
*Off AZTENA0 135
Aztec Code Msg. Length Minimum (1-3832) *1 AZTMIN#### 135
Maximum (1-3832) *3832 AZTMAX#### 135
Aztec Append *On AZTAPP1 135
Off AZTAPP0 135
Aztec Code Page Aztec Code Page (*51) AZTDCP## 136
Chinese Sensible (Han Xin) Code Default All Han Xin Code Settings HX_DFT 136
On HX_ENA1 136
*Off HX_ENA0 136
Chinese Sensible (Han Xin) Code
Msg. Length
Minimum (1-7833) *1 HX_MIN#### 136
Maximum (1-7833) *7833 HX_MAX#### 137
Postal Codes - 2D
2D Postal Codes *Off POSTAL0 137
Single 2D Postal Codes Australian Post On POSTAL1 137
British Post On POSTAL7 137