HP 5500 EI series - Page 175

164
# Configure RIPv2 on Router D.
[RouterD] rip 1
[RouterD-rip-1] network 10.0.0.0
[RouterD-rip-1] version 2
[RouterD-rip-1] undo summary
# Configure RIPv2 on Router E.
[RouterE] rip 1
[RouterE-rip-1] network 10.0.0.0
[RouterE-rip-1] version 2
[RouterE-rip-1] undo summary
# On Router D, configure IS-IS to redistribute routes from RIP.
[RouterD-rip-1] quit
[RouterD] isis 1
[RouterD–isis-1] import-route rip level-2
# Display IS-IS routing information on Router C.
[RouterC] display isis route
Route information for IS-IS(1)
-----------------------------
Level-1 IPv4 Forwarding Table
-----------------------------
IPv4 Destination IntCost ExtCost ExitInterface NextHop Flags
-------------------------------------------------------------------------------
10.1.1.0/24 10 NULL Eth1/1 Direct D/L/-
10.1.2.0/24 10 NULL Eth1/3 Direct D/L/-
192.168.0.0/24 10 NULL Eth1/2 Direct D/L/-
Flags: D-Direct, R-Added to Rib, L-Advertised in LSPs, U-Up/Down Bit Set
Level-2 IPv4 Forwarding Table
-----------------------------
IPv4 Destination IntCost ExtCost ExitInterface NextHop Flags
-------------------------------------------------------------------------------
10.1.1.0/24 10 NULL Eth1/1 Direct D/L/-
10.1.2.0/24 10 NULL Eth1/3 Direct D/L/-
192.168.0.0/24 10 NULL Eth1/2 Direct D/L/-
10.1.4.0/24 10 NULL Eth1/2 192.168.0.2 R/L/-
10.1.5.0/24 20 NULL Eth1/2 192.168.0.2 R/L/-
10.1.6.0/24 20 NULL Eth1/2 192.168.0.2 R/L/-
Flags: D-Direct, R-Added to Rib, L-Advertised in LSPs, U-Up/Down Bit Set