HP 5500 EI series - Page 244

233
Ste
p
Command Remarks
3. Enter BGP IPv6 unicast
address family view.
address-family ipv6 [ unicast ] N/A
4. Save all route updates from
the peer or peer group.
peer { group-name |
ipv6-address } keep-all-routes
By default, the routes are not
saved.
This command takes effect only for
the routes received after this
command is executed.
Configuring manual soft-reset
To configure manual soft-reset (IPv4):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enable BGP route refresh for a
peer or peer group.
• Enable BGP route refresh for the
specified peer or peer group:
peer { group-name |
ip-address }
capability-advertise
route-refresh
• Enable BGP route refresh and
multi-protocol extension
capability for the specified peer
or peer group:
undo peer { group-name |
ip-address }
capability-advertise
conventional
By default, BGP route refresh is
enabled.
4. Return to user view.
return N/A
5. Perform manual soft-reset.
refresh bgp { ip-address | all |
external | group group-name |
internal } { export | import } ipv4
[ unicast ] [ vpn-instance
vpn-instance-name ]
N/A
To configure manual soft-reset (IPv6):
Ste
p
Command Remarks
1. Enter system view.
system-view N/A