HP PROCURVE 2910AL User Manual

Key Management System
Configuring Key Chain Management
Adds a key with
full time and date
Adds a key with
duration
expressed in
seconds.
Figure 15-3. Adding Time-Dependent Keys to a Key Chain Entry
Note Given transmission delays and the variations in the time value from switch to
switch, it is advisable to include some flexibility in the Accept lifetime of the
keys you configure. Otherwise, the switch may disregard some packets
because either their key has expired while in transport or there are significant
time variations between switches.
To list the result of the commands in figure 15-3:
Figure 15-4. Display of Time-Dependent Keys in the Key Chain Entry
15-7

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)