HP ProCurve 5400zl User Manual

and changes current context to RIP Conguration Context.
Otherwise, the command disables RIP. The command can be
followed by a RIP conguration command. Use 'router rip ?' to
get a list of all possible options.
Next Available Options:
■ auto-summary -- Enable/disable advertisement of summarized routes(p. 476)
■ default-metric < 1 to 15 > -- Set default metric for imported routes(p. 478)
■ distance < 1 to 255 > -- Set administrative distance for routes learned via RIP(p. 479)
■ redistribute < connected | static | ospf > -- Specify source protocols which will be redistributed
into RIP(p. 485)
■ restrict -- Prevent redistribution of routes via RIP(p. 485)
rp-address
■ [no] router pim rp-address
Usage: [no] rp-address <IP-ADDR> [GROUP-ADDR/GROUP-MASK] [override]
Description: Statically congure the Rendezvous Point (RP) to accept
multicast trafc for specied group or range of groups.
If GROUP-ADDR/GROUP-MASK is not specied, the default multicast
group prex 224.0.0.0/4 (224.0.0.0 240.0.0.0) will be used.
To remove all entries associated with the RP or a specic
entry use 'no' form of the command.
Parameters:
o IP-ADDR - IP address of the Rendezvous Point.
o GROUP-ADDR - IP address of multicast group, when combined
with GROUP-MASK, gives the group prex.
o GROUP-MASK - Denes the range of multicast group addresses.
o override - Sets the precedence of statically congured RP higher
than dynamically learned RPs. Not set by default.
Next Available Option:
■ IP-ADDR -- Specify the IP address of the static RP. (IP-ADDR) (p. 481)
rp-candidate
■ [no] router pim rp-candidate
Usage: rp-candidate [source-ip-vlan <VLAN-ID>]
[group-prex <GROUP-ADDR/GROUP-MASK>]
[hold-time <30-255>]
[priority <0-255>]
no rp-candidate [source-ip-vlan <VLAN-ID>]
[group-prex <GROUP-ADDR/GROUP-MASK>]
Description: Congure router to advertise itself as the Candidate
Rendezvous Point (Candidate-RP) to the Bootstrap Router (BSR).
When enabling router to be a Candidate-RP the VLAN ID must
be specied, which IP address will be advertised as a
Candidate-RP's IP address. PIM-SM must be enabled on the VLAN.
If GROUP-ADDR/GROUP-MASK is not specied the router will be a
Candidate-RP for all multicast groups. Use 'no' form of this
487© 2009 Hewlett-Packard Development Company, L.P.
routerCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English