HP ProCurve 5400zl

■ fingerprint -- Display hexadecimal hash.(p. 552)
icmp
■ show ip icmp
Usage: show ip icmp
Description: Show ICMP Rate Limiting settings.
■ show rate-limit icmp
Show only limits for icmp trafc.
Next Available Options:
■ port-list -- Specify ports for which information will be shown. ([ethernet] PORT-LIST) (p. 578)
■ detailed -- Show Inbound Radius Override details.(p. 546)
if-ip
■ show ip ospf statistics IP-ADDR
Specify IP address of the interface for which to show detailed information.
■ show ip ospf interface IP-ADDR
Specify IP address of the interface for which to show detailed information.
■ show ip rip interface IP-ADDR
Specify IP address of the interface for which to show detailed information.
igmp
■ show igmp
Usage: show igmp [...]
Description: Show global switch IGMP conguration parameters.
To get a list of all possible parameters use 'show igmp ?'.
Next Available Option:
■ delayed-flush -- Shows switch-wide IGMP delayed flush value(p. 545)
■ show ip igmp
Usage: show ip igmp [cong|group IP-ADDR|VLAN-ID [cong]]
Description: Invoked without any parameters, shows per-VLAN IGMP status,
or, if VLANs are disabled displays the global IGMP status.
When followed by the 'cong' keyword, shows IGMP global
conguration information. VLAN-ID can be used to get
operational and conguration information for a particular
VLAN, if VLAN support is enabled. The 'group' keyword can be
used to show a list of ports where a particular multicast group
is registered.
556© 2009 Hewlett-Packard Development Company, L.P.
showCommand Line Interface Reference Guide