mld
â– show ipv6 mld
Usage: show ipv6 mld [conîš¿g|group IPV6-ADDR|VLAN-ID [conîš¿g]]
Description: Invoked without any parameters, shows per-VLAN MLD status,
or, if VLANs are disabled displays the global MLD status.
When followed by the 'conîš¿g' keyword, shows MLD global
conîš¿guration information. VLAN-ID can be used to get
operational and conîš¿guration information for a particular
VLAN, if VLAN support is enabled. The 'group' keyword can be
used to show a list of ports where a particular multicast group
is registered.
Next Available Options:
â– vlan -- Show MLD VLAN information.(p. 603)
â– config -- Show MLD configuration information.(p. 540)
â– statistics -- Show MLD statistics.(p. 594)
modules
â– show modules
Usage: show modules
Description: Show installed modules information
Next Available Option:
â– details -- (p. 547)
monitor
â– show instrumentation monitor
Usage: show instrumentation monitor
Description: Show latest values for monitored parameters.
The data displayed is dependent on which version of code is running.
Data is maintained for the current 5 minutes, hour, and day. At the end of
every 5 minutes, hour, or day, averages and min/max values are calculated
and the current interval's data is copied to the previous interval's data.
For example, the previous day's data is updated at midnight local time. The
previous hour's data is updated on the hour.
There are many situations in which data is not yet available, or data is
not maintained. In this case, an asterisk is displayed. It is never an
error condition.
Next Available Option:
â– configuration -- show configured thresholds for monitored parameters(p. 543)
â– show monitor
570© 2009 Hewlett-Packard Development Company, L.P.
showCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General