HP ProCurve 5400zl

Description: Show the stack status of this switch. The 'candidate' and
'view' commands are available on the stack commander only.
o candidates - show the list of devices that are stack candidates.
o view - show the list of devices that are stack members.
o all - show information about all the stacks available on the LAN.
Next Available Options:
■ candidates -- Show the list of devices that are stack candidates.(p. 537)
■ view -- Show the list of devices that are stack members.(p. 602)
■ all -- Show information about all the stacks available on the LAN.(p. 529)
static
■ show ip pim rp-set static
Show statically congured RP-Set information.
static-mac
■ show static-mac
Usage: show static-mac
Description: Show the locked-down MAC addresses in all vlans.
The list is sorted by VLAN, then MAC address.
statistics
■ show arp-protect statistics VLAN-ID-RANGE
■ show ip ospf statistics
Usage: show ip ospf statistics [IP-ADDR|vlan VLAN-ID]
Description: List OSPF packet statistics( OSPF sent,recieved and
error packet count) of all OSPF enabled interfaces.
If [IP-ADDR] specied list statistics for that interface if
the interface is OSPF enabled.
If [vlan [VLAN-ID] is specied list statistics for all OSPF enabled
interfaces of the given vlan.
Next Available Options:
■ vlan -- Specify VLAN of the interface for which to show detailed information. (VLAN-ID) (p. 603)
■ if-ip -- Specify IP address of the interface for which to show detailed information. (IP-ADDR)
(p. 556)
■ show ipv6 mld vlan VLAN-ID statistics
Show MLD VLAN statistics
■ show ipv6 mld statistics
Show MLD statistics.
594© 2009 Hewlett-Packard Development Company, L.P.
showCommand Line Interface Reference Guide