contact
■ snmp-server contact CONTACT
Name of the switch administrator.
dhcp-snooping
■ [no] snmp-server enable traps dhcp-snooping
Traps for DHCP-Snooping.
dst-ip-of-request
■ snmp-server response-source dst-ip-of-request
Destination Ip address of the snmp request pdu will be used as the
source ip address in the snmp response pdu.
dyn-ip-lockdown
■ [no] snmp-server enable traps dyn-ip-lockdown
Traps for Dynamic Ip Lockdown
enable
■ [no] snmp-server enable
Usage: [no] snmp-server enable
Description:Enable/Disable SNMPv1/v2.
Next Available Option:
■ traps -- Enable/disable event traps to be sent by the switch(p. 621)
events
■ snmp-server host IP-ADDR < None | Debug | All | ... >
Supported Values:
■ None -- Send no log messages.
■ Debug -- Send debug traps (for Internal use).
■ All -- Send all log messages
■ Not-INFO -- Send all but informational-only messages.
■ Critical -- Send critical-level log messages.
■ snmp-server host IPV6-ADDR < None | Debug | All | ... >
Supported Values:
■ None -- Send no log messages.
■ Debug -- Send debug traps (for Internal use).
■ All -- Send all log messages
■ Not-INFO -- Send all but informational-only messages.
■ Critical -- Send critical-level log messages.
excluded
■ snmp-server mib hpSwitchAuthMIB excluded
616© 2009 Hewlett-Packard Development Company, L.P.
snmp-serverCommand Line Interface Reference Guide
To Next Page
Loading...
