HP ProCurve 5400zl User Manual

Range: < 1 to 21474836 >
■ snmp-server host IPV6-ADDR informs timeout < 1 to 21474836 >
Specify the interval between retries for informs, in seconds.
Range: < 1 to 21474836 >
traps
■ [no] snmp-server enable traps
Usage: [no] snmp-server enable traps snmp-authentication <standard | extended>
[no] snmp-server enable traps port-security
[no] snmp-server enable traps login-failure-mgr
[no] snmp-server enable traps password-change-mgr
[no] snmp-server enable traps authorization
[no] snmp-server enable traps arp-protect
[no] snmp-server enable traps dhcp-snooping
[no] snmp-server enable traps dyn-ip-lockdown
[no] snmp-server enable traps link-change <PORT-LIST>
Description: Enable/disable event traps to be sent
by the switch.
Next Available Options:
■ link-change -- Traps for link-up and link-down. ([ethernet] PORT-LIST) (p. 618)
■ snmp-authentication -- Select RFC-1157 (standard) or HP-ICF-SNMP (extended) traps.(p. 620)
■ dhcp-snooping -- Traps for DHCP-Snooping.(p. 616)
■ arp-protect -- Traps for Dynamic ARP Protection.(p. 615)
■ dyn-ip-lockdown -- Traps for Dynamic Ip Lockdown(p. 616)
■ auth-server-fail -- Traps reporting authentication server unreachable.(p. 615)
■ password-change-mgr -- Traps for management interface password change.(p. 619)
■ login-failure-mgr -- Traps for management interface login failure.(p. 619)
■ port-security -- Traps for port access authentication failure.(p. 619)
trap-source
■ [no] snmp-server trap-source
Usage: [no] snmp-server trap-source [IP-ADDR|loopback<0-7>]
Description: Specify the source ip-address policy for the trap pdu.
By default snmp trap pdu will contain the ip address of
the active interface on which trap will be sent. The default
behavior is in compliance to rfc-1517.
The no form of the command will revert to default behavior.
IP-ADDR -- ip-address specied will be used as the source ip
address in the generated trap.
loopback 0-7 -- lexicographically minimum congured ip address on the
specied interface will be used as the source ip
address in the generated trap pdu.
Next Available Options:
■ ip-addr -- IP Address for the source ip address field in the trap pdu. (IP-ADDR) (p. 618)
■ loopback < 0 to 7 > -- For the specified loopback interface, lexicographically minimum configured
ip address will be used as the source ip address in the trap pdu.(p. 619)
621© 2009 Hewlett-Packard Development Company, L.P.
snmp-serverCommand Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English