HP ProCurve 5400zl

Description: Enable/Disable SNMP support for the hpSwitchAuthentication MIB.
When the MIB access is enabled, Manager read/write access
to the MIB is permitted. Operator read/write access to the MIB
is always denied. For security reasons, network administrators
are encouraged to disable SNMPV2c before using the MIB.
Next Available Options:
■ included -- Enables SNMP support for the hpSwitchAuthentication MIB.(p. 618)
■ excluded -- Disables SNMP support for the hpSwitchAuthentication MIB.(p. 616)
included
■ snmp-server mib hpSwitchAuthMIB included
Enables SNMP support for the hpSwitchAuthentication MIB.
informs
■ snmp-server host IP-ADDR informs
Specify if informs will be sent, rather than notications.
Next Available Options:
■ retries < 0 to 255 > -- Specify the number of retries for informs.(p. 620)
■ timeout < 1 to 21474836 > -- Specify the interval between retries for informs, in seconds.
(NUMBER) (p. 620)
■ snmp-server host IPV6-ADDR informs
Specify if informs will be sent, rather than notications.
Next Available Options:
■ retries < 0 to 255 > -- Specify the number of retries for informs.(p. 620)
■ timeout < 1 to 21474836 > -- Specify the interval between retries for informs, in seconds.
(NUMBER) (p. 620)
ip-addr
■ snmp-server response-source IP-ADDR
IP Address for the source ip address eld in the snmp response pdu.
■ snmp-server trap-source IP-ADDR
IP Address for the source ip address eld in the trap pdu.
link-change
■ [no] snmp-server enable traps link-change [ETHERNET] PORT-LIST
Traps for link-up and link-down.
location
■ snmp-server location LOCATION
618© 2009 Hewlett-Packard Development Company, L.P.
snmp-serverCommand Line Interface Reference Guide