HP ProCurve 5400zl

Description of the switch location.
login-failure-mgr
■ [no] snmp-server enable traps login-failure-mgr
Traps for management interface login failure.
loopback
■ snmp-server response-source loopback < 0 to 7 >
For the specied loopback interface, lexicographically minimum
congured ip address will be used as the source ip address in
the snmp response pdu.
Range: < 0 to 7 >
■ snmp-server trap-source loopback < 0 to 7 >
For the specied loopback interface, lexicographically minimum
congured ip address will be used as the source ip address in
the trap pdu.
Range: < 0 to 7 >
mib
■ snmp-server mib
Usage: snmp-server mib hpSwitchAuthMIB <excluded|included>
Description: Enable/Disable SNMP support for the hpSwitchAuthentication MIB.
When the MIB access is enabled, Manager read/write access
to the MIB is permitted. Operator read/write access to the MIB
is always denied. For security reasons, network administrators
are encouraged to disable SNMPV2c before using the MIB.
Next Available Option:
■ hpSwitchAuthMIB -- Enable/Disable SNMP support for the hpSwitchAuthentication MIB(p. 617)
password-change-mgr
■ [no] snmp-server enable traps password-change-mgr
Traps for management interface password change.
port-security
■ [no] snmp-server enable traps port-security
Traps for port access authentication failure.
response-source
■ [no] snmp-server response-source
Usage: [no] snmp-server response-source [IP-ADDR|dst-ip-of-request|
loopback<0-7>]
619© 2009 Hewlett-Packard Development Company, L.P.
snmp-serverCommand Line Interface Reference Guide