HP ProCurve 5400zl

Next Available Option:
■ tagvalue -- Set tag value that selects entries in the snmpTargetAddr table. (ASCII-STR) (p. 632)
only
■ [no] snmpv3 only
Accept only SNMP v3 messages.
params
■ [no] snmpv3 params PARAMS
Congure SNMPv3 Target Parameter entry.
Next Available Option:
■ user -- Set user that the switch will send messages on behalf. (ASCII-STR) (p. 632)
■ snmpv3 targetaddress TARGETADDRESS params PARAMS
Set parameter name.
Next Available Options:
■ ipaddr -- Set IP address of the destination target. (IP-ADDR) (p. 627)
■ ipv6addr -- Set IPv6 address of the destination target. (IPV6-ADDR) (p. 627)
port-mask
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR port-mask TCP/UDP-PORT
Set range of udp ports with this mask.
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR port-mask TCP/UDP-PORT
Set range of udp ports with this mask.
priv
■ snmpv3 user USERNAME auth AUTHPASSWORD priv
Set Privacy password.
Next Available Options:
■ privpassword -- Set Privacy password. (ASCII-STR) (p. 630)
■ privprotocol < DES | AES > -- Set privacy protocol. (p. 630)
■ snmpv3 user USERNAME auth < MD5 | SHA > AUTHPASSWORD priv
Set Privacy password.
Next Available Options:
■ privpassword -- Set Privacy password. (ASCII-STR) (p. 630)
■ privprotocol < DES | AES > -- Set privacy protocol. (p. 630)
629© 2009 Hewlett-Packard Development Company, L.P.
snmpv3Command Line Interface Reference Guide