HP ProCurve 5400zl

group
■ [no] snmpv3 group < ManagerPriv | ManagerAuth | OperatorAuth | ... >
Congure SNMPv3 User to Group entry.
Supported Values:
■ ManagerPriv -- Require privacy and authentication, can access all objects.
■ ManagerAuth -- Require authentication, can access all objects.
■ OperatorAuth -- Requires authentication, limited access to objects.
■ OperatorNoAuth -- No authentication required, limited access to objects.
■ ComManagerRW -- Community with manager and unrestricted write access.
■ ComManagerR -- Community with manager and restricted write access.
■ ComOperatorRW -- Community with operator and unrestricted write access.
■ ComOperatorR -- Community with operator and restricted write access.
Next Available Option:
■ user -- Set user to be added to the group. (ASCII-STR) (p. 632)
index
■ [no] snmpv3 community index INDEX
Set community index.
Next Available Option:
■ name -- Set community name. (ASCII-STR) (p. 628)
ipaddr
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR
Set IP address of the destination target.
Next Available Options:
■ addr-mask -- Set range of transport addresses with this mask. (IP-ADDR) (p. 625)
■ filter < None | Debug | All | ... > -- Set log filters. (p. 626)
■ max-msg-size < 484 to 65535 > -- Set maximum message size value; default is 1472. (p. 628)
■ port-mask -- Set range of udp ports with this mask. (TCP/UDP-PORT) (p. 629)
■ retries < 0 to 255 > -- Set retries value; default is 3. (p. 630)
■ timeout < 0 to 2147483647 > -- Set time-out value; default is 1500. (p. 632)
■ taglist -- Set list of values used to select this entry from snmpNotifyTable. (ASCII-STR) (p. 631)
■ udp-port -- Set UDP port number to which the messages are sent; default is 162.
(TCP/UDP-PORT) (p. 632)
ipv6addr
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR
Set IPv6 address of the destination target.
Next Available Options:
■ addr-mask -- Set range of transport addresses with this mask. (IP-ADDR) (p. 625)
■ filter < None | Debug | All | ... > -- Set log filters. (p. 626)
627© 2009 Hewlett-Packard Development Company, L.P.
snmpv3Command Line Interface Reference Guide