HP ProCurve 5400zl User Manual

Set list of values used to select this entry from snmpNotifyTable.
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR taglist TAGLIST
Set list of values used to select this entry from snmpNotifyTable.
tagvalue
■ snmpv3 notify NOTIFY tagvalue TAGVALUE
Set tag value that selects entries in the snmpTargetAddr table.
targetaddress
■ [no] snmpv3 targetaddress TARGETADDRESS
Congure SNMPv3 Target Address entry.
Next Available Option:
■ params -- Set parameter name. (ASCII-STR) (p. 629)
timeout
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR timeout < 0 to 2147483647
>
Set time-out value; default is 1500.
Range: < 0 to 2147483647 >
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR timeout < 0 to 2147483647
>
Set time-out value; default is 1500.
Range: < 0 to 2147483647 >
udp-port
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR udp-port TCP/UDP-PORT
Set UDP port number to which the messages are sent; default is 162.
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR udp-port TCP/UDP-PORT
Set UDP port number to which the messages are sent; default is 162.
user
■ [no] snmpv3 group < ManagerPriv | ManagerAuth | OperatorAuth | ... > user USER
Set user to be added to the group.
Next Available Option:
■ sec-model < ver1 | ver2c | ver3 > -- Set security model to be used. (p. 631)
■ snmpv3 params PARAMS user USER
Set user that the switch will send messages on behalf.
632© 2009 Hewlett-Packard Development Company, L.P.
snmpv3Command Line Interface Reference Guide

HP ProCurve 5400zl Specifications

General

Brand	HP
Model	ProCurve 5400zl
Category	Switch
Language	English