HP ProCurve 5400zl

vlan (p. 653)MSTID (p. 645)config-revision (p. 642)
VLAN-ID-RANGE (p. 653)path-cost (p. 646)force-version (p. 642)
pending (p. 647)forward-delay (p. 643)
point-to-point-mac (p. 648)global (p. 643)
admin-edge-port
■ [no] spanning-tree [ETHERNET] PORT-LIST admin-edge-port
Set the administrative edge port status.
apply
■ spanning-tree pending apply
Apply pending MSTP conguration (swaps active and pending conguratons).
auto
■ spanning-tree [ETHERNET] PORT-LIST path-cost auto
Use dynamic method of selecting a value for the path cost.
■ spanning-tree [ETHERNET] PORT-LIST path-cost auto
Use dynamic method of selecting a value for the path cost.
■ spanning-tree instance ist [ETHERNET] PORT-LIST path-cost auto
Use dynamic method of selecting a value for the path cost.
■ spanning-tree instance < 1 to 16 > [ETHERNET] PORT-LIST path-cost auto
Use dynamic method of selecting a value for the path cost.
auto-edge-port
■ [no] spanning-tree [ETHERNET] PORT-LIST auto-edge-port
Set the automatic edge port detection.
bpdu-filter
■ [no] spanning-tree [ETHERNET] PORT-LIST bpdu-filter
Stop a specic port or ports from transmitting BPDUs, receiving BPDUs, and assume a
continuous fowarding state.
bpdu-protection
■ [no] spanning-tree [ETHERNET] PORT-LIST bpdu-protection
Disable the specic port or ports if the port(s) receives STP BPDUs.
bpdu-protection-timeout
■ spanning-tree bpdu-protection-timeout < 0 to 65535 >
Set the time for protected ports to be in down state after receiving unauthorized
BPDUs.
641© 2009 Hewlett-Packard Development Company, L.P.
spanning-treeCommand Line Interface Reference Guide