HPE Cloudline CL3100 Gen10 - Page 162

Software and configuration utilities 162
Setup Item
Options
Help Text
Comments
Station MAC address
Information only. Displays the
Station MAC Address get from
BMC.
Router IP Address
Information only. Displays the
Router IP Address get from
BMC.
Router MAC Address
Information only. Displays the
Router MAC Address get from
BMC.
Configuration Address
Source
Unspecified
Static
DynamicBmcDhcp
Select to configure LAN channel
parameters statically or
dynamically (by BIOS or BMC).
An unspecified option does not
modify any BMC network
parameters during BIOS phase.
During BIOS phase, BIOS will
send IPMI command to change
BMC network IP source to this
item specified, after that, this
item’s value will revert back to
[Unspecified].
Current Configuration
Address source
Information only.
Station IP Address
Information only. Displays the
Station IP Address get from
BMC.
Subnet Mask
Information only. Displays the
Subnet Mask get from BMC.
Station MAC address
Information only. Displays the
Station MAC Address get from
BMC.
Router IP Address
Information only. Displays the
Router IP Address get from
BMC.
Router MAC Address
Information only. Displays the
Router MAC Address get from
BMC.
IPV6 Support
Enabled
Disabled
Enable or Disable LAN1 IPV6
Support.
If select to Disabled, IPv6
information will be hide and
show “IPV6 is not supported in
BMC (OR) IPV6 Support is
Disabled.” message.
Configuration Address
Source
Unspecified
Static
DynamicBmcDhcp
Select to configure LAN channel
parameters statically or
dynamically (by BIOS or BMC).
Unspecified option will not
modify any BMC network
parameters during BIOS phase.
Current Configuration
Address source
Information only.
Station IPV6 address
Information only.
Prefix Length
Information only.
IPV6 Router1 IP
Address
Information only.
IPV6 address status
Active
Information only.
IPV6 DHCP Algorithm
DHCPv6
Information only.
IPV6 Support
Enabled
Disabled
Enable or Disable LAN1 IPV6
Support.
If select to Disabled, IPv6
information will be hide and
.show “IPV6 is not supported in
BMC (OR) IPV6 Support is
Disabled.” message.