HPE ProLiant Gen9

• “because it is a singled ported drive”
• “because it is a SATA drive”
• “because it is smaller than the drive it is replacing”
• “because it is of an unrecognized type”
• “because it contains an unsupported RIS configuration”
Message ID: 24598
Severity: Informational
Log message: Logical drive <logical drive number> of array controller <controller
name / slot information> has encountered a status change from:
Status: <previous status>
to
Status: <current status>
<previous status> and <current status> values:
• “OK”
• “FAILED”
• “NOT CONFIGURED”
• “INTERIM RECOVERY MODE”
• “READY FOR RECOVERY”
• “RECOVERING”
• “WRONG PHYSICAL DRIVE REPLACED”
• “PHYSICAL DRIVE NOT PROPERLY CONNECTED”
• “HARDWARE IS OVERHEATING”
• “HARDWARE HAS OVERHEATED”
• “EXPANDING”
• “NOT YET AVAILABLE”
• “QUEUED FOR EXPANSION”
• “DISABLED DUE TO SCSI ID CONFLICT”
• “EJECTED”
• “ERASING”
• “UNKNOWN”
Message ID: 24599
Severity: Warning
Log message: Logical drive <logical drive number> of array controller <controller
name / slot information> has encountered a status change from:
180 HPE Smart Array errors