HPE ProLiant Gen9

• AUTOSENSE_FAILED - Drive is failing commands but is not returning SCSI sense
data after multiple retries.
• MEDIUM_ERROR_1 - Caused by a particular set of SCSI sense codes that indicate
the drive is in bad shape and its data may be corrupt.
• MEDIUM_ERROR_2 - Caused by a particular set of SCSI sense codes that indicate
the drive is in bad shape; retries did not help.
• NOT_READY_BAD_SENSE - Drive is returning unrecognized Not Ready sense codes.
• NOT_READY - Drive is not ready and will not spin up.
• HARDWARE_ERROR - Drive is returning a Hardware Error sense key; controller
unable to get drive back online.
• ABORTED_COMMAND - Drive is returning an Aborted Command sense key; controller
unable to get drive back online.
• WRITE_PROTECTED - Drive is returning a sense key indicating it is write
protected.
• SPIN_UP_FAILURE_IN_RECOVER - “Start Unit” command failed during error recovery
• REBUILD_WRITE_ERROR - Drive failed write command after multiple retries during
rebuild.
• TOO_SMALL_IN_HOT_PLUG - Replacement drive is too small for configured
volume(s).
• BUS_RESET_RECOVERY_ABORTED - Unable to communicate with drive after multiple
bus resets and retries; may be due to this drive or another drive that is
corrupting the parallel SCSI bus.
• REMOVED_IN_HOT_PLUG - Drive has been hot-removed.
• INIT_REQUEST_SENSE_FAILED - “Request Sense” command failed during device
discovery/initialization.
• INIT_START_UNIT_FAILED - “Start Unit” command failed during device discovery/
initialization.
• INQUIRY_FAILED - “Inquiry” command failed after multiple retries.
• NON_DISK_DEVICE - Attached device is not a hard disk per its inquiry data.
• READ_CAPACITY_FAILED - “Read Capacity” command failed after multiple retries.
• INVALID_BLOCK_SIZE - Drive indicates it is not formatted for 512 bytes per
sector.
• HOT_PLUG_REQUEST_SENSE_FAILED - “Request Sense” command failed after drive
hot-added.
• HOT_PLUG_START_UNIT_FAILED - “Start Unit” command failed after drive hot-
added)
• WRITE_ERROR_AFTER_REMAP - After reassigning a media error reported during a
write command, the write command failed with another media error.
• INIT_RESET_RECOVERY_ABORTED - Unable to communicate with drive during
initialization after multiple bus resets and retries; may be due to this drive
or another drive that is corrupting the parallel SCSI bus.
216 HPE Smart Array errors