HPE ProLiant Gen9

Severity: Error
Log message: Array controller <controller name / slot information> has reported
that its internal temperature has exceeded the preset limit of <temperature
limit>°C. The current temperature is <current temperature>°C as reported by
sensor number <sensor number>. The controller may attempt to shut down power
and/or spin down installed disk drives.
Message ID: 24792
Severity: Warning
Log message: Array controller <controller name / slot information> has reported
that its internal temperature is nearing the preset temperature limit of
<temperature limit>°C. The current temperature is <current temperature>°C as
reported by sensor number <sensor number>. The array controller may enact
precautionary measures to prevent data loss should the temperature reach the
operating limit.
Message ID: 24793
Severity: Informational
Log message: Array controller <controller name / slot information> has reported
that a previously existing temperature condition on the controller from sensor
<sensor number> has been corrected. All of the temperature sensors are now
reporting acceptable temperature levels.
Message ID: 24794
Severity: Error
Log message: The external Smart Array controller located in the MSA chassis labeled
as <chassis number> is indicating that sensor number <sensor number> has
reported that the internal temperature of <internal temperature>°C has exceeded
the preset temperature limit of <temperature limit>°C. The external Smart Array
controller may attempt to shut down power to and/or spin down installed disk
drives.
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
Message ID: 24795
Severity: Warning
Log message: The external Smart Array controller located in the MSA chassis labeled
as <chassis label> is indicating that its internal temperature is nearing the
preset temperature limit of <temperature limit>°C. The current temperature is
<current temperature>°C as reported by sensor number <sensor number>. The
external Smart Array controller may enact precautionary measures to prevent data
loss should the temperature reach the operating limit.
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
Message ID: 24796
Severity: Informational
Log message: The external Smart Array controller located in the MSA chassis labeled
as <chassis label> is indicating that a previously existing temperature
condition on the controller from sensor <sensor number> has been corrected. All
of the temperature sensors are now reporting acceptable temperature levels.
HPE Smart Array errors 221