311 Enclosure Dynamic Power Cap is not set. Cannot confirm that device tray meets minimum firmware
version required.
312 Enclosure Dynamic Power Cap not set. Device tray fails to meet the minimum required firmware version.
313 The requested cap is outside the allowable range of Enclosure Dynamic Power Cap values.
314 Server Power Reduction cannot currently be enabled. Enclosure Dynamic Power Cap is not allowed.
315 No valid ISO images found on USB key.
316 Bay privileges cannot be revoked for Administrators with OA permission.
317 Invalid DNS hostname.
318 Factory defaults cannot be restored because the enclosure is in VC mode.
319 The string entered is not a valid IPv6 address.
320 IPv6 static address already exists.
321 IPv6 static address not found.
322 Unable to add.
323 Invalid SMTP server.
324 Invalid SNMP Trap receiver.
325 Invalid NTP server.
326 Invalid EBIPA configuration. Multiple subnets were detected.
327 Specified VLAN ID does not exist.
328 Cannot delete the default VLAN ID.
329 Maximum VLAN entries reached.
330 Duplicated VLAN ID.
331 Specified VLAN ID is invalid.
332 Operation partially successful.
333 Duplicated VLAN name.
334 A pending command already exists.
337 The remote syslog server address cannot be cleared while remote logging is enabled.
338 Invalid search context number.
339 Not on the same VLAN ID domain.
340 This command is not valid for auxiliary blades.
341 No LDAP groups currently exist.
342 The requested Derated Circuit Capacity is outside the allowable range of values for this enclosure.
343 The requested Rated Circuit Capacity is outside the allowable range of values for this enclosure.
344 The requested cap is greater than the requested Derated Circuit Capacity.
345 The requested Derated Circuit Capacity is greater than the requested Rated Circuit Capacity.
346 The requested set of bays to exclude cause the cap to be outside the allowable range.
347 The requested set of bays to exclude cause the Derated Circuit Capacity to be outside the allowable
range.
348 The requested set of bays to exclude cause the Rated Circuit Capacity to be outside the allowable range.
353 IPv6 is currently disabled. Cannot download certificate from the specified address.
HPE Onboard Administrator errors 233
To Next Page
Loading...
