276 Network duplex setting must be HALF or FULL.
277 The password does not conform to password rules.
278 Invalid minimum password value
279 A firmware image is already staged.
280 The provided file was not a proper image.
281 Bad image CRC checksum
282 Remote system logging must be enabled to perform this operation.
283 Invalid remote port. The port must be a number between 1 and 65535.
284 The remote syslog server address must be configured before enabling remote system logging.
285 Invalid remote server address.
286 This setting is already enabled.
287 This setting is already disabled.
288 Enclosure IP mode was not enabled because the active Onboard Administrator does not have a static
IPv4 address.
289 This feature is not available for this Onboard Administrator.
290 Request to enable DHCP addressing on the active Onboard Administrator is denied because Enclosure
IP Mode is enabled.
291 The value provided is not proper base64.
292 The firmware image provided is an older version than the current firmware. Onboard Administrator
settings cannot be preserved.
293 The file provided is not a valid Onboard Administrator firmware image.
294 There are no USB keys connected to the enclosure.
295 No valid firmware images found on USB key.
296 No configuration scripts found on USB key.
297 I/O error on USB key.
298 Badly formatted USB file URL.
299 Permission problems when accessing USB media.
300 Error uploading to USB media.
301 An invalid number of GUIDs was passed to the Onboard Administrator.
302 URL flash image for microcode download not available.
303 Invalid session timeout.
304 Invalid watts value.
305 Failed to store change for power cap.
306 Enclosure Dynamic Power Cap feature is not allowed.
307 Wrong number of bays specified for enclosure while setting capping bays to exclude.
308 The number of bays opted out exceeds the maximum allowed.
309 Enclosure Dynamic Power Cap feature is not allowed.
310 Enclosure Dynamic Power Cap is set.
232 HPE Onboard Administrator errors
To Next Page
Loading...
