HPE ProLiant Gen9 - Page 260

OA: Blade [value:bladeNumber] PCI device missing...state is CRITICAL.
OA: Blade [value:bladeNumber] PCI device missing...state is DEGRADED.
OA: Blade [value:bladeNumber] PCI device missing...state is DEGRADED.
OA: Blade [value:bladeNumber] Power Control fault...state is CRITICAL.
OA: Blade [value:bladeNumber] Power Control fault...state is DEGRADED.
OA: Blade [value:bladeNumber] properly partners with its neighbor.
OA: Blade [value:bladeNumber] reported an unusually high power allocation value.
Please see customer advisory c01668472. Its invalid power value of [value]W has
been capped at [value]W.
OA: Blade [value:bladeNumber] requested too little power.
OA: Blade [value:bladeNumber] Storage Condition fault...state is CRITICAL.
OA: Blade [value:bladeNumber] Storage Condition fault...state is DEGRADED.
OA: Blade [value:bladeNumber] thermal state is CRITICAL.
OA: Blade [value:bladeNumber] thermal state is DEGRADED.
OA: Blade in bay #[value:bladeNumber] status changed from [OK/Degraded/Failed]
to [OK/Degraded/Failed]
OA: Blade in bay #[value:bladeNumber] status changed to [OK/Degraded/Failed]
OA: Blade removed from bay [value:bladeNumber]
OA: Blade removed from bay [value:bladeNumber]
OA: DC Subsystem Overload - FAILED. Redundant Power: [value]W DC, Present Power
[value]W AC.
OA: Ekeying: Partner device of blade [value:bladeNumber] was removed, no more
mezzanine card required on blade [value:bladeNumber].
OA: Fan Removed: Bay #[value:fanNumber]
OA: Fan Status Changed: Bay #[value:fanNumber] From: [degraded/failed/ok] To:
[degraded/failed/ok]
OA: Fan Subsystem Status Changed: From: [degraded/failed/ok] To: [degraded/
failed/ok]
OA: Hewlett Packard Enterprise strongly recommends replacing power supply
#[value] at the customer's earliest possible convenience pursuant to Customer
Advisory c01519680.
OA: Internal communication problem detected.
OA: Internal communications restored.
OA: Internal health status of interconnect in bay [value:slotNumber] changed to
Degraded
OA: Internal health status of interconnect in bay [value:slotNumber] changed to
Failed
OA: Internal health status of interconnect in bay [value:slotNumber] changed to
Unknown
OA: Management Processor on Blade [value:bladeNumber] appears unresponsive.
OA: Mixing different fan models is not supported. The fan in bay
#[value:fanNumber] must be replaced with the proper part number.
260 HPE Onboard Administrator errors