OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] DIMM
records which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] NIC records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data requires [value] DIMM records.
[value] are supported by this OA firmware version.
OA: Enclosure Dynamic Power Cap: Device tray firmware doesn't meet minimum
required version.
OA: Enclosure Dynamic Power Cap: Server Power Reduction is not enabled;
enclosure cap is not guaranteed if power redundancy is lost.
OA: Fan Inserted: Bay #[value:fanNumber]
OA: iLO in bay [value:bladeNumber] appears responsive to the Enclosure Dynamic
Power Cap again.
OA: iLO in bay [value:bladeNumber] is not responding to capping requests from
the Enclosure Dynamic Power Cap. Reset the iLO.
OA: Server Power Reduction - Deactivated
OA: Tray Update: Can't get TRAY PS microcode version
OA: Warning: integrated device on bus 0x[value] at address 0x[value] has not
responded
Log type: LOG_NOTICE, Failure type: Info
OA: AC Subsystem Overloaded - REPAIRED
OA: Blade [value:bladeNumber] Ambient Temperature Cable state is OK.
OA: Blade [value:bladeNumber] Ambient Temperature Sensor state is OK.
OA: Blade [value:bladeNumber] Ambient Temperature state is OK.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade is not a supported model.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade reports that it is not capable of dynamic power capping.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade does not have the required iLO license.
OA: Blade [value:bladeNumber] complies with location rules now.
OA: Blade [value:bladeNumber] Disk Tray is Open state is OK.
OA: Blade [value:bladeNumber] firmware management completed.
OA: Blade [value:bladeNumber] firmware management started.
OA: Blade [value:bladeNumber] found a partner device.
OA: Blade [value:bladeNumber] FRU memory state is OK.
OA: Blade [value:bladeNumber] has been allocated [value] watts but iLO is
reporting the blade is powered off.
OA: Blade [value:bladeNumber] has been denied power but iLO is reporting the
blade is powered on.
OA: Blade [value:bladeNumber] Internal Temperature Sensor state is OK.
OA: Blade [value:bladeNumber] Internal Temperature state is OK.
262 HPE Onboard Administrator errors
To Next Page
Loading...
