HPE ProLiant Gen9

OA: Blade [value:bladeNumber] is now configured for Virtual Connect Manager.
OA: Blade [value:bladeNumber] is properly cooled.
OA: Blade [value:bladeNumber] is reporting nominal health status.
OA: Blade [value:bladeNumber] Main Logic Board state is OK.
OA: Blade [value:bladeNumber] over temperature state is OK.
OA: Blade [value:bladeNumber] PCI device state is OK.
OA: Blade [value:bladeNumber] PCI device state is OK.
OA: Blade [value:bladeNumber] Power Control state is OK.
OA: Blade [value:bladeNumber] Storage Condition state is OK.
OA: Blade [value:bladeNumber] thermal state is OK.
OA: Blade inserted in bay [value:bladeNumber]
OA: DC Subsystem Overloaded - REPAIRED
OA: Enclosure ID setting has been restored to factory defaults
OA: Fan Inserted: Bay #[value:fanNumber]
OA: Internal health status of interconnect in bay [value:slotNumber] changed to
OK
OA: IO module in slot [value:slotNumber] temperature is normal
OA: Management Process on Blade [value:bladeNumber] appears responsive again.
OA: Midplane replacement detected. Serial number changed from [value] to
[value].
OA: Mixing 400Hz PSs with other PSs is not supported
OA: Power Limit Set To: [value]
OA: Power Limit Set To: Not Set
OA: Power Subsystem Redundancy Mode Set To: [N+N/N+1/N+0/]
OA: Power Supplies Connected To Both AC and DC Input Lines: REPAIRED
OA: PS Inserted: Bay #[value]
OA: PS Subsystem N + 1 Redundancy - REPAIRED
OA: PS Subsystem N + 1 Redundancy Power Limit - REPAIRED
OA: PS Subsystem N + N Redundancy - REPAIRED
OA: PS Subsystem N + N Redundancy Power Limit - REPAIRED
OA: PS Subsystem Overloaded - REPAIRED
OA: PS Subsystem Power Limit - REPAIRED
OA: Redundant Onboard Administrator was inserted
OA: Server Power Reduction - Activated
OA: Server Power Reduction Mode - Disabled
OA: Server Power Reduction Mode - Enabled
OA: Server Power Reduction Mode - Enabled
OA: TRAY microcode updated from UNKNOWN version to version [value:version]
HPE Onboard Administrator errors 263