Event log display Event log explanation
iLO reset by user diagnostics iLO was reset by user for diagnostics. This is
typically initiated from the Diagnostic page of the iLO
web user interface.
iLO reset for Firmware upgrade iLO was reset to apply firmware updates.
iLO Self Test Error: [error code] iLO has failed an internal test. The probable cause is
that a critical component has failed. Further use of
iLO on this server is not recommended.
iLO SNMP settings modified by: [user name] The SNMP was modified by the listed user.
iLO time update failed. Unable to contact NTP server iLO was unable to synchronize the time with the NTP
server because the server cannot be reached.
iLO updated the host Date and Time. iLO updated the server onboard clock.
iLO was hard reset by a local user or device iLO was hard reset by a local user or device
iLO was reset because a FIPS Known Answer Test
failed
iLO was reset because a FIPS Known Answer Test
failed.
iLO was reset for network link auto-detection iLO was reset for network link auto-detection.
iLO was soft reset by a local user, device or
enclosure
iLO was soft reset by a local user, device or
enclosure
Integrated Remote Console Trust Settings disabled
by: [user name]
The IRC Trust Setting was disabled by the listed
user. A trusted SSL certificate would be required to
launch the IRC.
Integrated Remote Console Trust Settings Enabled
by: [user name]
The IRC Trust Setting was enabled by the listed user.
A trusted SSL certificate would be required to launch
the IRC.
IPMI/RMCP login by [user name] - [IP address and
DNS name]
The listed user logged in to iLO via IPMI/RMCP from
the listed IP address and DNS name.
IPMI/RMCP login failure from: [IP address and DNS
name]
An attempt to login to iLO via IPMI/RMCP failed from
the listed IP address and DNS name.
IPMI/RMCP logout: [user name] - [IP address and
DNS name]
The listed user logged out of iLO via IPMI/RMCP
from the listed IP address and DNS name.
Key manager configuration modified by: [user name] The key manager configuration was modified by the
listed user.
Key manager redundancy modified by: [user name] The key manager redundancy setting was modified
by the listed user.
Language pack added Language pack was installed.
Language pack removed Language pack was removed.
Language pack upgrade failed An error occurred while iLO attempted to update the
language pack.
License activation error by: [user name] The license activation key cannot be installed.
Possibly the activation key was invalid or not
supported.
Table Continued
306 HPE iLO messages, traps, and errors
To Next Page
Loading...
