HPE ProLiant Gen9

Event log display Event log explanation
Group Power Cap for [group] disabled by: [user
name]
The Group Power Cap for the listed iLO Federation
Group was disabled by the listed user.
Group Power Cap for [group] set to [value] by: [user
name]
The Group Power Cap for the listed iLO Federation
Group was set to the listed value by the listed user.
Host server reset by: [user name] The server was reset (warm-rebooted) by the list
user.
Hotkey modified by: [user name] Hotkey settings were modified by the listed user.
iLO clock has been synchronized with [IP address] iLO clock has been synchronized with the NTP
server at the listed IP address.
iLO clock has been synchronized with the Onboard
Administrator
iLO clock has been synchronized with the
BladeSystem Onboard Administrator.
iLO Federation Group [group] added by: [user name] The listed iLO Federation Group was added to this
iLO by the listed user.
iLO Federation Group [group] deleted by: [user
name]
The listed iLO Federation Group was deleted from
iLO by the listed user.
iLO Federation Group [group] modified by: [user
name]
The listed iLO Federation Group was modified by the
listed user.
iLO Federation Management login failure from: [IP
address and DNS name]
An attempt to login by the iLO Federation
Management failed.
iLO Federation Management login: [user name] - [IP
address and DNS name]
The iLO Federation Management logged in with the
listed user name from the listed IP address and DNS
name.
iLO Federation Management logout: [user name] -
[IP address and DNS name]
The iLO Federation Management logged out with the
listed user name from the listed IP address and DNS
name.
iLO Management Processor reset iLO was restarted.
iLO Management Processor reset iLO was reset by the firmware, typically to apply
settings.
iLO Management Processor reset to factory defaults iLO was reset to factory defaults. All configurations
are restored to the factory defaults.
iLO memory error detected at [address] iLO detected a correctable memory error at the listed
address.
iLO Network Configuration modified by [user name] The iLO network configuration was modified by the
listed user.
iLO network link down iLO was not connected to a network
iLO network link up at [link speed] iLO network connection was established at the listed
speed
iLO RBSU exited The iLO RBSU session ended. User logged out and
the iLO RBSU exited.
iLO RBSU login failure An attempt to login to iLO via the iLO RBSU failed.
iLO RBSU login: [user name] The listed user logged in to iLO via the iLO RBSU.
Table Continued
HPE iLO messages, traps, and errors 305