HPE ProLiant Gen9

Event log display Event log explanation
Directory settings modified by: [user name] The directory settings were modified by the listed
user.
Duplicate IP address [IP address] detected on
network.
Duplication of the listed IP address was detected.
Dynamic Power Cap disabled by : [user name] The server dynamic power cap was disabled by the
listed user.
Dynamic Power Cap set to [value] by : [user name] The server dynamic power cap was set to the listed
value by the listed user.
Embedded Flash/SD-CARD: [status details] The status of the Embedded Flash/SD card.
Enforce AES/3DES encryption disabled: [user name] Enforcement of AES/3DES encryption was disabled
by the listed user.
Enforce AES/3DES encryption enabled: [user name] Enforcement of AES/3DES encryption was enabled
by the listed user.
eRS - [status] The status of the embedded Remote Support
subsystem.
Event log cleared The iLO event log was cleared.
Event log cleared by: [user name] The iLO event log has been cleared by the listed
user.
Excessive network delay while communicating with
virtual [virtual media device]
The virtual media connection timed out due to
excessive network delay while communicating with
the listed virtual media device.
FIPS Mode Enabled The FIPS-compliant mode was enabled.
FIPS Mode was disabled and iLO was reset because
of multiple Known Answer Test failures.
FIPS mode was disabled and iLO was reset to the
factory defaults because there were multiple FIPS
Known Answer Test failures.
Firmware reset by [source] for network modifications. iLO was reset by the listed source for network
modifications.
Firmware reset to use new hardware iLO was reset to use new hardware.
Firmware upgrade complete Firmware upgrade has completed.
Firmware upgrade started from: [IP address and
DNS name]
Firmware update was initiated from the listed IP
address and DNS name.
Firmware upgrade via CLI failed An attempt to update the firmware via the CLI failed.
Firmware upgrade via online flash component failed An attempt to update the firmware using the online
flash component failed.
Firmware upgrade via web page failed Firmware update did not complete successfully.
Make sure the firmware image file is correct.
Firmware upgrade via XML failed Firmware upgrade via RIBCL script failed. Make sure
the firmware image file is correct.
Firmware upgraded to version [version] Firmware was successfully updated to the listed
version.
Table Continued
304 HPE iLO messages, traps, and errors