HPE ProLiant Gen9 - Page 308

Event log display Event log explanation
Remote console login failure from: [IP address and
DNS name]
An attempt to login to use the iLO Remote Console
has failed. The request came from the listed IP
address and DNS name.
Remote console session shared by: [IP address and
DNS name]
A shared remote console session was established
for the listed IP address and DNS name.
Remote console started by: [user name] - [IP
address and DNS name]
The remote console session was started by the listed
user from the listed IP address and DNS name.
Remote console started by: [user name] - [IP
address and DNS name]
The remote console session was closed by the listed
user from the listed IP address and DNS name.
Remote Syslog modified by: [user name] The Remote Syslog settings were modified by the
listed user.
Rest API Info: Rest API Provider Added [provider
index]
A REST API provider was added at the listed index.
Rest API Warning: Rest API memory cleared
[reason]
The REST API memory was cleared for the listed
reason.
Rest API Warning: Rest API Provider Removed
[reason]
A REST API provider was removed for the listed
reason.
RIBCL AHS count cleared by: [user name] The AHS counter for RIBCL was cleared by the listed
user.
ROM Swap: System ROM has been swapped to
backup ROM by: [user name]
System ROM has been swapped to backup ROM by
the listed user.
Scriptable virtual media ejected by: [user name] Scriptable virtual media was ejected by the listed
user.
Scriptable Virtual Media HTTP error [error code] iLO received an HTTP error with the listed error code
from the scriptable virtual media hosting server.
Scriptable virtual media inserted by: [user name] Scriptable virtual media was inserted by the listed
user.
Scripted Virtual Media could not establish a
connection to [URL]
iLO could not establish a connection with the listed
URL to use as a scriptable virtual media device.
Security jumper override detected. Security disabled! The security-override jumper was added on the
system board (not recommended). Security was
disabled (overridden).
Security jumper setting normal The security-override jumper is not added on the
system board (recommended). Security settings
operate normally.
Serial CLI login failure An attempt to login to iLO from the Serial CLI failed.
Serial CLI login: [user name] The listed user logged in to iLO via the Serial CLI.
Serial CLI logout: [user name] The listed user logged out of iLO via the Serial CLI.
Serial CLI session started A Serial CLI session started.
Serial CLI session stopped A Serial CLI session stopped.
Table Continued
308 HPE iLO messages, traps, and errors