Event log display Event log explanation
Server cumulative power on time cleared by [user
name] - [IP address and DNS name]
The server cumulative power-on time was cleared by
the listed user from the listed IP address and DNS
name.
Server FQDN changed by: [user name] The server Fully Qualified Domain Name was
modified by the listed user.
Server Name changed by: [user name] The server name was modified by the listed user.
Server power loss caused by: [cause]. Attempt to
restore server power in [duration].
The server power was lost due to the listed cause.
iLO will attempt to restore the server power after the
listed duration.
Server power removed The server power is turned off.
Server power restored The server power is turned on.
Server reset The server was reset (warm-rebooted).
Shared remote console session has disconnected:
[IP address and DNS name]
The shared remote console session was
disconnected from the listed IP address and DNS
name.
SMH FQDN changed by: [user name] The Fully Qualified Domain Name of the System
Management Homepage was modified by the listed
user.
SNMP Alert on Breach of Power Threshold modified
by: [user name]
The SNMP Alert on Breach of Power Threshold
setting was modified by the listed user.
SNTP server settings modified by: [user name] The NTP servers were modified by the listed user.
SSH key for [user 1] added by: [user 2] The SSH key was added for user 1 by user 2.
SSH key for [user 1] removed by: [user 2] The SSH key for user 1 has been removed by user
2.
SSH login failure from: [IP address and DNS name] An attempt to login to iLO failed from the listed IP
address and DNS name, via SSH.
SSH login: [user name] - [IP address and DNS
name]
The listed user logged in to iLO via SSH from the
listed IP address and DNS name.
SSH logout: [user name] - [IP address and DNS
name]
The listed user logged out of iLO via SSH from the
listed IP address and DNS name.
SSL Certificate installed by : [user name] An SSL certificate was installed on iLO by the listed
user.
SSO [role] role privileges set by user: [user name] The SSO role (administrator, operator, user...) was
set to listed role by the listed user.
SSO login attempt from [IP address] via [SSO server]
as [SSO role] by user: [user name]
The listed user attempted to login to iLO using SSO
from the listed IP address and SSO server.
SSO rejected An attempt to login to iLO using SSO was rejected.
SSO rejected: Certificate mismatch An attempt to login to iLO using SSO was rejected
because the SSO certificate was not trusted.
SSO rejected: not enabled An attempt to login to iLO using SSO was rejected
because SSO was not enabled.
Table Continued
HPE iLO messages, traps, and errors 309
To Next Page
Loading...
