HPE ProLiant Gen9 - Page 366

• cpqDaTapeDrvBusIndex
• cpqDaTapeDrvScsiIdIndex
• cpqDaTapeDrvLunIndex
Supporting SNMP Trap Description: “Cleaning is needed for the tape drive.”
NT Event ID: 1184 (Hex)0x843504a0 (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: Drive Array Tape Drive Replace Cleaning Tape.
Log Message: The cleaning tape in the tape drive in slot %4, SCSI bus %5, SCSI target %6 needs to be
replaced.
SNMP Trap: cpqDaTapeDriveCleanTapeReplace - 3024 in CPQIDA.MIB
Symptom: Tape Drive Cleaning Tape Needs Replacing. The agent has detected that an autoloader tape unit
has a cleaning tape that has been fully used and therefore needs to be replaced with a new cleaning tape.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqDaTapeDrvCntlrIndex
• cpqDaTapeDrvBusIndex
• cpqDaTapeDrvScsiIdIndex
• cpqDaTapeDrvLunIndex
Supporting SNMP Trap Description: “Cleaning tape needs replacing.”
NT Event ID: 1185 (Hex)0x843504a1 (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: Fibre Channel Controller Status Change.
Log Message: The Fibre Channel Controller in slot %4 has a new status of %5.
SNMP Trap: cpqFca2HostCntlrStatusChange - 16021 in CPQFCA.MIB
Symptom: Fibre Channel Host Controller Status Change. This trap indicates that the agent has detected a
change in the status of a Fibre Channel Host Controller. The variable cpqFcaHostCntlrStatus indicates the
current controller status.
User Action: If the controller status is failed, replace the controller.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqFcaHostCntlrSlot
• cpqFcaHostCntlrStatus
• cpqFcaHostCntlrModel
• cpqFcaHostCntlrWorldWideName
366 HPE Insight Management Agents for Servers for Windows