HPE ProLiant Gen9 - Page 367

Supporting SNMP Trap Description: “Host controller in slot [cpqFcaHostCntlrSlot] has a new status of
[cpqFcaHostCntlrStatus].”
NT Event ID: 1186 (Hex)0x843504a2 (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: IDE ATA Disk Status Change.
Log Message: The ATA disk drive with model %6 and serial number %7 has a new status of %2.
SNMP Trap: cpqIdeAtaDiskStatusChange - 14004 in CPQIDE.MIB
Symptom: ATA Disk Status Change. This trap indicates that the agent has detected a change in the status of
an ATA disk drive. The variable cpqIdeAtaDiskStatus indicates the current disk drive status.
User Action: If the physical drive status is smartError(3), failed(4) or ssdWearOut(5) replace the drive.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqIdeAtaDiskControllerIndex
• cpqIdeAtaDiskIndex
• cpqIdeAtaDiskModel
• cpqIdeAtaDiskFwRev
• cpqIdeAtaDiskSerialNumber
• cpqIdeAtaDiskStatus
• cpqIdeAtaDiskChannel
• cpqIdeAtaDiskNumber
Supporting SNMP Trap Description: “Status is now [cpqIdeAtaDiskStatus] for the ATA disk.”
NT Event ID: 1187 (Hex)0x843504a3 (cpqstmsg.dll)
Log Severity: Warning (2)
Event Title: ATA RAID Logical Drive Status Change.
Log Message: ATA RAID logical drive number %6 on the “%5” in slot %4 has a new status of %2.
SNMP Trap: cpqIdeLogicalDriveStatusChange - 14005 in CPQIDE.MIB
Symptom: IDE Logical Drive Status Change. This trap indicates that the agent has detected a change in the
status of an IDE logical drive. The variable cpqIdeLogicalDriveStatus indicates the current logical drive status.
User Action: If the logical drive status is failed(5), examine the array for failed drives that need replacement.
Supporting SNMP Trap Data:
• sysName
• cpqHoTrapFlags
• cpqIdeControllerModel
• cpqIdeControllerSlot
• cpqIdeLogicalDriveControllerIndex
HPE Insight Management Agents for Servers for Windows 367