Log Severity: Warning (2)
Log Message: Unable to open the registry key “%1”. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqnimsg.dll - 265 (Hex)0x84350109 (Service Event)
Log Severity: Warning (2)
Log Message: Unable to read “%1” from the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqnimsg.dll - 266 (Hex)0x8435010a (Service Event)
Log Severity: Warning (2)
Log Message: Unable to read “%1” from the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqnimsg.dll - 267 (Hex)0x8435010b (Service Event)
Log Severity: Warning (2)
Log Message: Unable to write “%1” to the registry. This error can be caused by a corrupt registry or a low
memory condition. Rebooting the server may correct this error.
Event identifier: cpqnimsg.dll - 268 (Hex)0x8435010c (Service Event)
Log Severity: Warning (2)
Log Message: Unable to enumerate “%1” from the registry. This error can be caused by a corrupt registry or a
low memory condition. Rebooting the server may correct this error.
Event identifier: cpqnimsg.dll - 269 (Hex)0xc435010d (Service Event)
Log Severity: Error (3)
Log Message: The NIC Management Agent encountered a fatal error. The service is terminating. The data
contain the error code.
Event identifier: cpqnimsg.dll - 270 (Hex)0x8435010e (Service Event)
Log Severity: Warning (2)
Log Message: Unable to create thread. This error can be caused by a low memory condition. Rebooting the
server may correct this error.
Event identifier: cpqnimsg.dll - 271 (Hex)0x8435010f (Service Event)
Log Severity: Warning (2)
Log Message: Could not open the driver for device “%1”. This error can be caused by an improperly installed
adapter. Removing and reinstalling the device may correct the problem. The data contain the error code.
Event identifier: cpqnimsg.dll - 272 (Hex)0x84350110 (Service Event)
Log Severity: Warning (2)
Log Message: Failure in driver %1. This error can be caused by an outdated driver version. Installing a later
version of the driver may correct the problem. The data contain the error code.
Event identifier: cpqnimsg.dll - 273 (Hex)0x84350111 (Service Event)
Log Severity: Warning (2)
Log Message: There were no physical adapters in team: “%1.” This error can be caused by improperly
installed drivers. Remove all device instances associated with the team and re-install the drivers and team.
Event identifier: cpqnimsg.dll - 274 (Hex)0x84350112 (Service Event)
Log Severity: Warning (2)
HPE Insight Management Agents for Servers for Windows 447
To Next Page
Loading...
