Action
Update the software or firmware to a revision with a valid certificate. For more information, see "Keeping the
system current" in the HPE ProLiant Gen9 Troubleshooting Guide, Volume I on the Hewlett Packard
Enterprise website.
279-Cable Error
Symptom
279-Cable Error - An internal cable routed to the LED Board is not plugged in or plugged in incorrectly. Action:
Plug in the internal cable correctly.
Cause
The LED board cable is not connected correctly.
Action
Install and route in the internal LED board cable correctly. For more information, see the user guide on the
Hewlett Packard Enterprise website.
280-Cable Error
Symptom
280-Cable Error - An internal cable routed to the SUV connector is not plugged in or plugged in correctly.
Action: Plug in the internal cable correctly.
Cause
An internal cable is not connected correctly.
Action
Connect and route the internal cable correctly. For more information, see the user guide on the Hewlett
Packard Enterprise website.
281-IMPORTANT: SW12 is ON indicating physical presence
Symptom
281-IMPORTANT: SW12 is ON indicating physical presence. This switch should only be ON to override
certain security protections. Action: Power down the server and put SW12 OFF if physical presence is not
required.
Cause
The SW12 switch is set to ON.
62 279-Cable Error
To Next Page
Loading...
