Return to the system view.
5. Run:
interface interface-type interface-number
The interface view of VLANIF interface connecting CE is displayed.
6. Run:
ripng process-id enable
RIPng is configured on the interface.
NOTE
The command can not be used in the interface view if the IPv6 is not enabled. The command
is not supported on the ATM interface.
7. Run:
quit
Return to the system view.
8. Run:
bgp as-number
The BGP view is displayed.
9. Run:
ipv6-family vpn6-instance vpn6-instance-name
The BGP-VPN6 instance view is displayed.
10. Run:
import-route ripng process-id [ med med | route-policy route-policy-name ]
*
The RIPng routes are imported into the routing table of BGP-VPNv6 instance.
After the running of the import-route ripng command in the BGP-VPNv6 instance
view, the PE imports the RIPng routes learnt from its CE into BGP, forms them into
VPN-IPv6 routes and advertise them to the remote PE.
NOTE
After a RIPng multi-instance process is deleted, RIPng is disabled on all the interfaces that run
this process.
After an IPv6 VPN instance is deleted, all the related RIPng processes are also deleted.
l Configuring OSPFv3 Between PE and CE
Configure OSPFv3 on the CE. For the detailed configuration about OSPFv3, refer to the
Quidway S7700 Smart Routing Switch Configuration Guide - IP Routing.
Configure an OSPFv3 multi-instance on the PE and configure BGP and OSPFv3 to import
routes from each other.
1. Run:
system-view
The system view is displayed.
2. Run:
ospfv3 [ process-id ] [ vpn6-instance vpn6-instance-name ]
OSPFv3 multi-instance is created and the OSPFv3 multi-instance view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
336
To Next Page
Loading...
