One OSPFv3 instance belongs to only one IPv6 VPN Instance. If an OSPFv3 process
is not bound to an IPv6 VPN Instance , the OSPFv3 process is a public process. In
addition, the public OSPFv3 instance cannot be bound to an IPv6 VPN Instance.
3. Run:
router-id router-id
A router ID is set.
If no router ID is specified, OSPFv3 selects a router ID from IP addresses of the
interfaces bound to the IPv6 VPN Instance based on the router ID selection rule.
4. Run:
import-route bgp [ cost cost | route-policy route-policy-name | tag tag |
type type ]
*
BGP routes are imported into OSPFv3 so that the PE uses OSPFv3 to send these routes
to the CE.
5. Run:
quit
The system is displayed.
6. Run:
interface interface-type interface-number
The view of the interface bound to a VPN instance is displayed.
7. Run:
ospfv3 process-id area area-id [ instance instance-id ]
OSPFv3 is enabled on the interface.
8. Run:
quit
The system is displayed.
9. Run:
bgp as-number
The BGP view is displayed.
10. Run:
ipv6-family vpn6-instance vpn6-instance-name
The BGP-VPN6 instance view is displayed.
11. Run:
import-route ospfv3 process-id [ med med | route-policy route-policy-
name ]
*
OSPFv3 are imported routes into the BGP-VPN6 instance routing table.
NOTE
After an IPv6 VPN instance has been deleted, all associated OSPFv3 processes will be deleted.
l Configuring IS-ISv6 Between PE and CE
You can configure the common IS-ISv6 on the CE.
The configurations on CE are not mentioned here.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 4 BGP MPLS IPv6 VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
337
To Next Page
Loading...
