LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status LAM SsnRole SsnAge KASent/Rcv
------------------------------------------------------------------------------
1.1.1.9:0 Operational DU Active 0000:00:14 57/57
2.2.2.9:0 Operational DU Active 0000:00:14 56/56
4.4.4.9:0 Operational DU Passive 0000:00:05 22/22
5.5.5.9:0 Operational DU Passive 0000:00:12 52/52
------------------------------------------------------------------------------
TOTAL: 4 session(s) Found.
<S-PE> display mpls ldp peer
LDP Peer Information in Public network
A '*' before a peer means the peer is being deleted.
------------------------------------------------------------------------------
PeerID TransportAddress DiscoverySource
------------------------------------------------------------------------------
1.1.1.9:0 1.1.1.9 Remote Peer : 1.1.1.9
2.2.2.9:0 2.2.2.9 Vlanif30
4.4.4.9:0 4.4.4.9 Vlanif40
5.5.5.9:0 5.5.5.9 Remote Peer : 5.5.5.9
------------------------------------------------------------------------------
TOTAL: 4 Peer(s) Found.
<S-PE> display mpls lsp
----------------------------------------------------------------------
LSP Information: LDP LSP
----------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.9/32 3/NULL -/-
1.1.1.9/32 NULL/1024 -/Vlanif30
1.1.1.9/32 1024/1024 -/Vlanif30
2.2.2.9/32 NULL/3 -/Vlanif30
2.2.2.9/32 1025/3 -/Vlanif30
4.4.4.9/32 NULL/3 -/Vlanif40
4.4.4.9/32 1027/3 -/Vlanif40
5.5.5.9/32 NULL/1027 -/Vlanif40
5.5.5.9/32 1026/1027 -/Vlanif40
Step 5 Create and configure the PW template.
Create a PW template on each U-PE. Enable the CW and LSP ping function.
# Configure U-PE1.
[U-PE1] pw-template pwt
[U-PE1-pw-template-pwt] peer-address 3.3.3.9
[U-PE1-pw-template-pwt] control-word
[U-PE1-pw-template-pwt] quit
# Configure U-PE2.
[U-PE2] pw-template pwt
[U-PE2-pw-template-pwt] peer-address 3.3.3.9
[U-PE2-pw-template-pwt] control-word
[U-PE2-pw-template-pwt] quit
Step 6 Create a VC connection.
Enable MPLS L2VPN on U-PE1, U-PE2, and S-PE.
Configure the dynamic PW on the U-PE. Enable dynamic PW switching on the S-PE.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
651
To Next Page
Loading...
