EasyManua.ls Logo

Huawei quidway s7700 - Page 667

Huawei quidway s7700
833 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE
PWE3 does not support point-to-multipoint (P2MP). When you create an MPLS L2VC on an ATM sub-
interface, the ATM sub-interface must be in the point-to-point (P2P) type. When you configure the
transparent transmission of ATM cells, the type of the ATM sub-interface is not restricted.
# Configure U-PE1.
[U-PE1] mpls l2vpn
[U-PE1-l2vpn] quit
[U-PE1] interface vlanif 10
[U-PE1-Vlanif10] mpls l2vc pw-template pwt 100
[U-PE1-Vlanif10] quit
# Configure S-PE.
[S-PE] mpls l2vpn
[S-PE-l2vpn] quit
[S-PE] mpls switch-l2vc 1.1.1.9 100 between 5.5.5.9 200 encapsulation vlan
# Configure U-PE2.
[U-PE2] mpls l2vpn
[U-PE2-l2vpn] quit
[U-PE2] interface vlanif 60
[U-PE2-Vlanif60] mpls l2vc pw-template pwt 200
[U-PE2-Vlanif60] quit
After the preceding configuration, run the display mpls l2vc interface command on U-PEs to
check L2VPN connections. You can see that PWs are set up and in Active state. In addition, you
can find that the BFD for PW function is disabled on the PWs.
Take the display on U-PE1 for example.
<U-PE1> display mpls l2vc interface vlanif 10
*client interface : Vlanif10 is up
Administrator PW : no
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 3.3.3.9
local group ID : 0 remote group ID : 0
local VC label : 23552 remote VC label : 23552
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
local status code : 0x0
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
local status code : 0x0
BFD for PW : available
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : cw alert lsp-ping bfd
remote VCCV : cw alert lsp-ping bfd
local control word : enable remote control word : enable
tunnel policy : --
traffic behavior : --
PW template name : pwt
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL type : lsp , TNL ID : 0x20023
create time : 0 days, 0 hours, 2 minutes, 40 seconds
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 6 PWE3 Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
652

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals