[UPE-Vlanif200] mpls rsvp-te
[UPE-Vlanif200] quit
2. Configure IS-IS TE.
# Configure the UPE.
[UPE] isis 1
[UPE-isis-1] cost-style wide
[UPE-isis-1] traffic-eng level-2
[UPE-isis-1] quit
3. Set up MPLS LDP sessions.
Set up MPLS LDP sessions between UPE and NPEs. Set the IP addresses of LDP remote
peers to the MPLS LSR-IDs of remote devices.
# Configure the UPE.
[UPE] mpls ldp
[UPE-ldp] quit
[UPE] mpls ldp remote-peer 2.2.2.2
[UPE-mpls-ldp-remote-2.2.2.2] remote-ip 2.2.2.2
[UPE-mpls-ldp-remote-2.2.2.2] quit
[UPE] mpls ldp remote-peer 3.3.3.3
[UPE-mpls-ldp-remote-3.3.3.3] remote-ip 3.3.3.3
[UPE-mpls-ldp-remote-3.3.3.3] quit
After the configuration, LDP sessions are established between the UPE and NPEs. Run the
display mpls ldp session command, and you can see that the status of the LDP sessions is
Operational.
Take the display on the UPE and NPE1 as an example:
[UPE] display mpls ldp session
LDP Session(s) in Public Network
Codes: LAM(Label Advertisement Mode), SsnAge Unit(DDDD:HH:MM)
A '*' before a session means the session is being deleted.
------------------------------------------------------------------------------
PeerID Status LAM SsnRole SsnAge KASent/Rcv
------------------------------------------------------------------------------
2.2.2.2:0 Operational DU Passive 0000:00:00 4/4
3.3.3.3:0 Operational DU Passive 0000:00:00 2/2
------------------------------------------------------------------------------
TOTAL: 2 session(s) Found.
4. Configure tunnel interfaces.
Create the tunnel interfaces on UPE and NPEs, and set the tunnel protocol to MPLS TE
and the singnaling protocol to RSVP-TE.
# Configure the UPE.
[UPE] interface tunnel 1/0/1
[UPE-Tunnel1/0/1] ip address unnumbered interface loopback1
[UPE-Tunnel1/0/1] tunnel-protocol mpls te
[UPE-Tunnel1/0/1] destination 2.2.2.2
[UPE-Tunnel1/0/1] description TO NPE1
[UPE-Tunnel1/0/1] mpls te tunnel-id 1
[UPE-Tunnel1/0/1] mpls te commit
[UPE-Tunnel1/0/1] quit
[UPE] interface tunnel 1/0/2
[UPE-Tunnel1/0/2] ip address unnumbered interface loopback1
[UPE-Tunnel1/0/2] tunnel-protocol mpls te
[UPE-Tunnel1/0/2] destination 3.3.3.3
[UPE-Tunnel1/0/2] description TO NPE2
[UPE-Tunnel1/0/2] mpls te tunnel-id 2
[UPE-Tunnel1/0/2] mpls te commit
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 8 VPLS Convergence Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
814
To Next Page
Loading...
