After the configuration, run the display ip interface brief command, and you can see that
the protocol status of the created tunnel interface is Up.
5. Configure the tunnel policy.
# Configure the UPE.
[UPE] tunnel-policy policy1
[UPE-tunnel-policy-policy1] tunnel select-seq cr-lsp load-balance-number 1
[UPE-tunnel-policy-policy1] quit
Step 3 Configure VPLS.
1. Create the mVSI on the UPE. The mVSI performs only local packet exchange.
The mVRRP packets are exchanged between the NPEs through the mVSI on the UPE.
# Configure the UPE.
[UPE] mpls l2vpn
[UPE-l2vpn] quit
[UPE] vsi admin-vsi1 static
[UPE-vsi-admin-vsi1] pwsignal ldp
[UPE-vsi-admin-vsi1-ldp] vsi-id 10
[UPE-vsi-admin-vsi1-ldp] quit
[UPE-vsi-admin-vsi1] admin-vsi
[UPE-vsi-admin-vsi1] quit
[UPE] interface gigabitethernet 1/0/1.1
[UPE-GigabitEthernet1/0/1.1] control-vid 1 dot1q-termination
[UPE-GigabitEthernet1/0/1.1] dolt1q termination vid 10
[UPE-GigabitEthernet1/0/1.1] l2 binding vsi admin-vsi1
[UPE-GigabitEthernet1/0/1.1] quit
[UPE] interface gigabitethernet 1/0/2.1
[UPE-GigabitEthernet1/0/2.1] control-vid 2 dot1q-termination
[UPE-GigabitEthernet1/0/2.1] dolt1q termination vid 10
[UPE-GigabitEthernet1/0/2.1] l2 binding vsi admin-vsi1
[UPE-GigabitEthernet1/0/2.1] quit
After the configuration, run the display vsi command on the UPE, and you can see that the
VSI status is Up.
Take the display on the UPE as an example:
[UPE] display vsi name admin-vsi1 verbose
***VSI Name : admin-vsi1
Administrator VSI : yes
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Diffserv Mode : uniform
Mpls Exp : --
Ignore AcState : disable
DomainId : 255
Domain Name :
Create Time : 0 days, 3 hours, 30 minutes, 31 seconds
VSI State : up
VSI ID : 10
Interface Name : GigabitEthernet1/0/1.1
State : up
Last Up Time : 2009/03/15 15:41:59
Total Up Time : 0 days, 0 hours, 1 minutes, 2 seconds
Interface Name : GigabitEthernet1/0/2.1
State : up
Last Up Time : 2009/03/15 15:41:59
Total Up Time : 0 days, 0 hours, 1 minutes, 2 seconds
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN 8 VPLS Convergence Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
815
To Next Page
Loading...
